How to Fit Your New Race Laces


TRANSCRIPTION

How to install your new elastic Race Laces.

Hey & welcome to the Race Lace tutorial.How to install your race laces

In this short tutorial I’m going to walk you through how to install your new elastic race laces.

When you have opened your packet you should have the following:

  • 2 x Laces in the colour of your choice approximately 120 cm or 48 inches long
  • 2 x Locking Caps
  • 2 x Lace clamps

Before you start, you should have removed your old shoelaces from your trainers.

Place your foot in your trainers before you start lacing them up, this ensures you get a comfortable fit.

Thread through your new Race Lace then pull the cord through so that you don’t have any slack in the laces. Don’t pull them too tight as you can adjust them later.

Next you need to thread through both ends of your new laces one at a time through the locking cap, remember to push down the cap to release the race lace clamps when your doing this.

Keep your finger pushed down on the button and slide the race lace clamp towards the tongue of your trainers and then release. This will lock your laces in place so that they can’t move.

Then you need to get a pair of scissors so that you can cut the cord to length, we recommend leaving approximately 2-3” or 5-8cm but this is entirely up to you.

Lastly, all you need to do is attach the lace clamps. Simply thread the ends of the cord through the hole. It is important that the end of the cut cords line up the teeth inside the clamp, finally press down firmly.

Now, you’re ready !! You’re Race Laces are installed they look awesome, you’ll be looking awesome wearing them, and they’re guaranteed for the life of your shoe!!

There are 8 colours to choose from have you got them all yet?

Visit: www.theracelace.com